TROUBLESHOOTING GUIDELINES (E-TEC AND ACE)
ENGINE LACKS ACCELERATION OR POWER (cont’d)
8. Drive belt worn too thin.
– If the drive belt ha s lost more than 3 mm (1/8 in) of its original width, it will af-
fect vehicle performance.
– Replace drive belt.
9. Incorrect track adjustment.
– See MAINTENANCE and/or an authorized Lynx dealer for proper alignment
and tension adjustments.
10.R.A.V.E. valves problem.
– Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
11.Fuel pressure too low.
– Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
ENGINE BACKFIRES
1. Engine is running too hot.
– See item 5 of ENGINE LACKS POWER.
2. Ignition timing is incorrect or there is an ignition system failure.
– Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
3. Exhaust system leak.
– Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
4. Fuel pressure too low.
– Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
ENGINE MISFIRES
1. Water in fuel.
– Drain fuel sys tem and refill with fresh fuel.
2. RAVE valves m alfunction.
– Have RAVE valves system inspec
ted. Seek service from an authorized Lynx
dealer, repair shop, or person of your own choosing for maintenance, repair,
or replacement.
NO RESPONSE FROM THE THROTTLE LEVER INPUTS. MESSAGE DISPLAYED:
PRESS START TO GO
1. Engine management system has detected a sensor problem.
– Press and hold the Start/electronic reverse button in order to move vehicle.
Seek service from an authorized Lynx dealer, repair shop, or person of your
own choosing for maintenance, repair, or replacement.
______________
145
To Next Page
Loading...
Need help?
General
