INJECTION OIL (E-TEC)
Recommended Injection
Oil
E-TEC Models
RECOMMENDED INJECTION OIL
ENGINES
XPS SYNTHETIC 2-STROKE OIL(F)
(P/N 619 590 106)
600 HO E-TEC
NOTICE
The engine of this snowmobile has been developed and validated
using the recommended BRP XPS™ oil. BRP recomm ends the use of its rec-
ommended XPS oil or equivalent. Damages caused by oil which is not suit-
able for this oil injected 2-stroke direct fuel injection engine may not be cov-
ered by the BRP limited warranty.
Injection Oil Level Verification
The injection oil reservoir is located
behind the RH side panel. See
BODY
in
MAINTENANCE PROCEDURES
for
opening procedure.
Always maintain a sufficient amount of
recommended injection oil in the injec-
tion oil reservoir.
NOTICE
Check level and refill ev-
ery time you refuel.
mmo2013-004-021_a
TYPICAL
1. Oil reservoir
2. 3/4 level
3. 1/2 level
4. 1/4 level
To Add Injection Oil
Remove injection oil reservoir cap.
Add injection oil.
NOTE: D o not exceed the maximum
level tab in the oil tank neck.
Reinstall cap and fully tighten.
NOTICE
Do not mismatch oil
reservoir cap with fuel tank cap.
WARNING
Wipe off any oil spills. Oil is highly
flammable when heated.
_______________
77
To Next Page
Loading...
Need help?
General
