OPERATING MODES (ACE)
To activate Sport mode when in ECO
mode, press top end of switch twice.
To activate Standard mode when in
ECO mode, press top end of switch
once.
fmo2014-002-012_c
TYPICAL
Step 1: Press top end of switch
WARNING
When adjusting modes, be sure to
maintain situational awareness of
other snowmobiles, obstacles, or
persons .
Learning Key Modes
The learning key provides a mode of
operation whereby engine torque and
speed are limited.
NOTE: The initial learning key pro-
gramming can limit the speed
to 40 km/h (25 MPH) or 70 km/h
(43 MPH). Refer to your authorized
Lynx dealer to modify this setting.
There are 3 levels available for the
learning key mode.
Changing Learning Key Settings
To change learning key setting, carry
out the following:
1. Press the START/electronic reverse
button to wake up the electrical sys-
tem and install the NORMAL key on
the engine cut-off switch.
2. Wait for the information center to
complete its self-test and disp
lay
the key recognition message.
Analog/Dig ital Gauge
3. Press the SET button until LEARN is
visible in the digital screen of the in-
formation center.
Multifunction Analog/Digital Gauge
4. Press the MODE button once, then
press the SET button until LEARN
is visible in the digital center of the
gauge.
mmo2007-009-066_o
mmo2007-009-066_w
All Models
5. Use the heated grip switch to toggle
the key setting between 1 and 3.
80
______________
To Next Page
Loading...
Need help?
General
