Lynx TS Series - Page 8

8
TS Series | User Manual
04. GAIN SELECTION
Gain conguration from 26 to 40 dB.
05. GPI CONTROL
GPI Power: On/off by maintained contact or voltage.
GPI Mute: Mute/unmute completelly amplier by contact or voltage.
06. CHANNEL SETUP
50Hz HP: 50Hz subsonic lter.
07. GPO MONITOR
GPIO for third party interface. AES67 and Dante options.
08. GPO STATUS
Monitor each individual channel, with switching contacts for fault/ OK status.
09. SPEAKER OUTPUTS
Up to 10000 W in 4 channels.
10. OUTPUT MODE
Output Mode: Hi impedance voltage selector. Low impedance power limitation.
Bridge mode: Low impedance bridge mode. 200V/140V high impedance mode.
11. SIGNAL INPUTS
- Input Link: Linking of input signals in consecutive channels.
- Output Levels: Hidden potentiometers on the rear for adjusting output levels.
1. INTRODUCTION
4
9
7
13
5
6
8
10
12
11