34
When set to Program IN/DC (PG IN/DC), these are the available parameters:
Type: The Encoder will send the next (Increment) or previous (Decrement) value number in
the range of values when you turn it.
Minimum: The lowest Program value in the range of values will correspond with this setting.
Available Values: 0-127
Maximum: The highest Program value in the range of values will correspond with this setting.
Available Values: 0-127
When set to CC Cycle, these are the available parameters:
CC: The Encoder will send its MIDI messages using this CC number.
Available Values: 0-127
Values: The Encoder will send the value with this CC number when you turn it, one at a time,
cycling through them with each notch.
Available Values:
• 2 Values
• 3 Values
• 4 Values
First: The Encoder will send the MIDI CC number with this value when you first turn it.
Available Values: 0-127
Second: The Encoder will send the MIDI CC number with this value at the second notch of the
turn.
Available Values: 0-127
Third: The Encoder will send the MIDI CC number with this value at the third notch of the turn.
Available Values: 0-127
Last: The Encoder will send the MIDI CC number with this value at the final notch of the turn.
Available Values: 0-127
When set to CC IN/DC, these are the available parameters:
CC: The Encoder will send its MIDI messages using this CC number.
Available Values: 0-127
Min: The lowest value in the range of values will correspond with this setting.
Available Values: 0-127
Max: The highest value in the range of values will correspond with this setting.
To Next Page
Loading...
