41
FS3
To edit the functionality of the FS3 (footswitch 3) input when in Preset Edit Mode, press the
footswitch. You can scroll through the available parameter values using the Encoder. Select
what parameter you would like to edit by pressing the Encoder.
• Latch: When Latch is enabled, the pedal will send one value when pressed and a
different value when pressed a second time, alternating between the two values with
each press (“latching” or “toggle” behavior). When Latch is disabled, the pedal will send
one value when pressed and one value when released (“momentary” behavior).
• Chan: The sustain pedal will send its messages over this channel. Select the global
channel (Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels
(Omni).
• CC: The sustain pedal will send its MIDI messages using this CC number.
• Min: The lowest program in the range of programs will correspond with this value.
• Max: The highest program in the range of programs will correspond with this value.
Saving a Preset
To store a Preset:
1. Press SHIFT and the Preset button to enter Edit Mode.
2. Edit a control as outlined in the Preset Edit Mode section of this guide.
3. Press the Preset button.
4. The display will show “SAVE?” with the following selections available.
• Cancel: Selecting “Yes” to Cancel will revert any changes made.
• Replace: Selecting “Yes” to Replace will write over the currently selected preset.
• Save As: Selecting “Yes” to Save As enable you to choose what number
“LOCATION” the preset will be and edit/change what the preset’s name “NAME” is.
The last available selection in the Save As screen is Save. Pressing “Yes” on the
Save screen will save your new preset.
Note: When editing a preset name, use the Encoder to scroll to a letter you want to
edit and press the Encoder to select the current letter. To erase a letter in a preset
name, press SHIFT and the Back button.
To Next Page
Loading...
