32/56 Installation
Bosch Rexroth AG, A22VG Series 40, RE 93221-01-B/07.2013
1 Protection plug/threaded plug 2 Protection cover
Ports intended for connecting lines are covered by protection plugs or threaded
plugs, which serve as transport protection. All ports required for functional
operation must be connected (see Table 10 “Ports A22VG series 40 series 40” on
page36). If this requirement is disregarded, malfunction or damage may result.
If a port is not connected, it must be plugged with a threaded plug because
protection plugs are not pressure-resistant.
The setting screws are protected against unauthorized resetting by means of
protection caps. Removing the protection caps will void the warranty. If you need
to change settings, contact your responsible Bosch Rexroth Service partner (for
address, see chapter 10.5 “Spare parts” on page 45.
3. For versions with through drive, install the auxiliary pump according to the pump
manufacturer’s instructions.
1
2
Fig. 12: Removing transport protection
To Next Page
Loading...