Operation 43/56
RE 93221-01-B/07.2013, A22VG Series 40, Bosch Rexroth AG
9 Operation
The product is a component which requires no settings or changes during operation.
For this reason, this chapter of the manual does not contain any information on
adjustment options. Use the product only within the performance range provided in
the technical data. The machine/system manufacturer is responsible for the proper
project planning of the hydraulic system and its control.
10 Maintenance and repair
NOTE
Inspection and maintenance work carried out too late!
Damage to equipment!
▶ Carry out the specified inspection and maintenance work at the intervals
described in this manual.
10.1 Cleaning and care
NOTE
Damage to seals and electrical system by mechanical effects!
The water jet of a high-pressure cleaner may damage the seals and electrical
system of the axial piston unit!
▶ Do not point the high-pressure cleaner at sensitive components, e.g. shaft seal,
electrical connections and components.
For cleaning and care of the axial piston unit, observe the following:
▶ Check whether all seals and fittings on the connections are securely seated to
ensure that no moisture can penetrate into the axial piston unit during cleaning.
▶ Use only water and, if necessary, a mild detergent to clean the axial piston unit.
Never use solvents or aggressive detergents.
▶ Remove external coarse dirt and keep sensitive and important components, such
as solenoids, valves and sensors, clean.
To Next Page
Loading...