Need help?Do you have a question about the MA lighting grand MA and is the answer not in the manual?
General| Category | Lighting Console |
|---|---|
| Manufacturer | MA Lighting |
| SMPTE | Yes |
| HIPS | No |
| Motorized Faders | Yes |
| Ethernet | Yes |
| MIDI | Yes, In/Out/Thru |
| Touchscreen | Yes |
Steps to safely open the Grand MA unit for component access, including power disconnection and lid handling.
Procedures for disconnecting internal components, removing the HDD or DMX board, and re-connecting cables.
Steps to safely open the Grand MA unit for component access, including power disconnection and lid handling.
Procedures for removing the PC ATX board and adapters, followed by unit reassembly.
Warning that PC ATX board must be removed first; instructions for reassembling the PCB.
Details on removing display adapter cables, unlocking plugs, and paying attention to jumper settings.
Steps to safely open the Grand MA unit for component access, including power disconnection and lid handling.
Procedures for removing the network adapter and reassembling the unit, noting nut tightening.
Steps to safely open the Grand MA unit for component access, including power disconnection and lid handling.
Procedures for removing the display panel, disconnecting cables, and reattaching the touch screen.
Steps to safely open the unit and remove initial components like screws and the spring locking pin.
Procedures for replacing the hydraulic trigger and adjusting the pneumatic spring for correct travel.
Steps to safely open the unit, disconnect power supply cables, and remove fastening screws.
Procedures for setting voltage values after power supply replacement and reinstallation.
To Next Page
