To Next PageTo Next Page
Need help?Do you have a question about the Maaselan Kone Oy Hakki Pilke 37 Series and is the answer not in the manual?
General| Model | Hakki Pilke 37 Series |
|---|---|
| Manufacturer | Maaselan Kone Oy |
| Category | Log Splitter |
| Max. log diameter | 37 cm |
| Engine Power | Not specified in the general specifications, depends on the chosen model (tractor PTO, electric, or combustion engine) |
Explains the manual's purpose and user responsibilities.
Details the intended use and limitations of the log splitter.
Provides technical specifications and model details for different variants.
Specifies the environmental and site requirements for safe operation.
Outlines critical safety rules for operating the machine.
Details the noise and vibration levels produced by the machine.
Explains the meaning of various safety and warning symbols used on the machine.
Guide for checking the machine and its components upon delivery.
Instructions for safely lifting and transporting the log splitter.
Identifies and illustrates the primary parts of the log splitter.
Step-by-step guide for installing initial components.
Procedures for setting up the machine for work or transport.
Detailed steps for adjusting the input conveyor's position.
Instructions for positioning the output conveyor for transport.
Explains the connection and operation of the tractor drive system.
Details the connection and operation of the electric drive system.
How to set log measurement and blade height.
Guide to operating and adjusting the output conveyor.
Instructions for adjusting oil flow to the blade chain.
How to operate and adjust the input conveyor.
Guidance on using the input conveyor guard and wood press.
Procedures for performing a test run before normal operation.
Recommends devices and safe practices for placing logs.
Steps for feeding logs and performing the sawing operation.
Troubleshooting steps for when the cutting blade gets jammed.
Specific instructions for sawing the final piece of wood.
Step-by-step guide for performing the wood splitting action.
Procedures for dealing with wood jammed on the splitting blade.
How to split wood again or without cutting.
Instructions for adjusting the stroke length of the splitting motion.
Explanation of the valve and splitting lever operations.
How the automatic acceleration valve works and how to adjust it.
Steps to follow after finishing the operation of the machine.
Troubleshooting and maintenance for the cutting blade and drive.
Guide to maintaining the blade chain, including replacement and sharpening.
Instructions for removing and installing the cutting flange.
Procedures for replacing and tensioning the V-belts.
Steps for replacing and adjusting the blade chain belt.
Guide to replacing and tensioning angle transmission belts.
Instructions for changing the oil in the angle transmission.
Steps for changing the hydraulic oil in the machine.
Guide to replacing and adjusting the input conveyor belt.
How to adjust the hydraulic pressure for the input conveyor motor.
Steps to replace and tighten the output conveyor belt.
Instructions for replacing the plates on the output conveyor.
How to adjust the hydraulic pressure for the output conveyor motor.
Identifies lubrication points and frequency for moving parts.
Procedures for cleaning the machine to ensure proper operation.
Guidelines for storing the machine when not in use.
A summary table of maintenance tasks and intervals.
Lists common problems and their solutions.
Provides electrical schematics for the machine.
Details the warranty conditions and compliance declarations.
Official declaration of machine compliance with EU directives.
