To Next PageTo Next Page
Need help?Do you have a question about the mabe Centauro ICL2040 Series and is the answer not in the manual?
Defines model codes for Brand, Product, Fuel, Capacity, etc.
Continues defining model codes for Washing System, Plug, V/Hz, Control Type.
Explains the serial number format and meaning.
Lists differences and common characteristics between washing center models.
Covers general, location, plumbing, tool, material, gas, and electric requirements.
Instructions for exhaust, packaging removal, moving, and leveling.
Connects gas supply and checks for leaks.
Connects exhaust, plumbing, and power cord for electric models.
Provides technical data for washer and dryer motors.
Data for lid lock switch, water valves, termoactuator, and pump.
Details washer controls like cycles, temperature, load size, water level, functions, and start/pause.
Details dryer controls like cycles, temperature, and load size.
Lists and describes wash programs, temperature, and load settings.
Explains Sanitized cycle, temperature, and load size selection.
Explains water level selection options.
Explains automatic, personal touch, and option modes like Eco and Rinse only.
Describes the wash/spin and rinse/spin functions.
Provides recommended garment amounts for loads.
Explains automatic drying cycle operation.
Dryer temperature and load size settings.
Explains timed drying cycles and how to start the dryer.
Instructions for lint filter and exhaust system maintenance.
Describes standard and Sanitized cycle sequences.
Explains Bulky cycle operation and spin protection.
Steps to remove front panel, cover, and lid lock.
Steps to remove tub cover and disconnect hoses/harness.
Steps to remove suspension rods, subwasher, and tub assembly.
Steps to remove impeller cap, screw, and impeller.
Steps to remove left nut, basket washer, and basket.
Steps to remove tub washer and basket bottom.
Steps to remove balance ring, plastic bottom, and disconnect harnesses.
Steps to remove harness transmission, band, and motor components.
Steps to remove transmission pulley and clutch components.
Steps to remove shifter and transmission assembly.
Steps for drive assembly and drain pump removal.
Steps for drain hose and cover removal.
Steps to remove cabinet harness and access panel.
Steps to remove control board and capacitor.
Steps to remove control board support and water valve.
Steps to remove the access panel back.
Steps to remove control panel knobs and panel.
Steps to remove selectors and T Board.
Steps to remove dryer harnesses and front panel.
Steps to remove drum belt and drum.
Steps to remove the motor bracket.
Steps to remove motor bracket lock and mica heater.
Steps to remove idler arm and thermostats.
Lists connectors, loads, and voltages for the control board.
Troubleshooting common washing machine problems.
Addresses operational issues with the washing machine.
Troubleshooting washer performance problems like wet clothes or spots.
Troubleshooting wrinkles and general dryer problems.
Troubleshooting wrinkled or shrunken clothes in the dryer.
Procedures for clearing volatile and non-volatile faults.
Steps to enter the service mode.
Description of available service mode tests.
Explains the operation of electric and gas dryers.
Explains dryer temperature levels and control operations.
Lists causes for poor dryer performance.
Provides an exploded view of the drive system assembly.
Details of the supports assembly.
Details of the 4:1 transmission.
Details of the tub seal.
General
