31
EN
In more detail...
MPWP2700 by MacAllister
Care and maintenance
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you find broken and worn parts
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualified
specialist!
General cleaning
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
Note: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using the
product again.
Maintenance
Before and after each use, check the product and accessories (such as
application tools) for wear and damage. If required, exchange them for new ones
as described in this instruction manual. Observe the technical requirements.
Spare parts/Replacement parts
The following parts of this product may be replaced by the consumer. Spare parts
are available at an authorized dealer or through our customer service.
Description Model no. or Specication
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 31 5/28/20 8:31 AM
To Next Page
Loading...
