Mac allister MPWP2700 - Page 36

EN
36
EN
In more detail...
MPWP2700 by MacAllister
Troubleshooting
Troubleshooting
Problem Possible cause Solution
4. Strong
pressure
fluctuation
4.1. Nozzle clogged 4.1. Clean the nozzle
4.2. Water inlet volume is
too low
4.2. Increase water inlet
quantity
4.3. High-pressure hose
is leaking
4.3. Replace high-pressure
hose
4.4. Seals worn 4.4. Contact our nearest
authorised service
centre
4.5. Intake filter dirt 4.5. Clean the filte
4.6. Air being sucked into
the system
4.6. Check thickness of hose
fitting
5. Water leakage
from product
5.1. Seals worn 5.1. Contact your nearest
authorised service
centre
6. Excessive
vibration/noise
6.1. Screws and nuts
loosened
6.1. Check screws and nuts
for tightness and re-
tighten as necessary
6.2 Motor problems 6.2 Contact your nearest
authorised service
centre
6.3 Water inlet volume is
too low
6.3 Increase water inlet
quantity
7. No detergent
taken in
7.1. Soap tank not
attached
7.1. Attach the soap tank
7.2 Detergent too dense 7.2 Dilute with water
7.3 Deposits or restriction
in detergent circuit
7.3 Flush with clean
water and eliminate
any restrictions. If
the problem persists,
contact an authorised
service centre
8. No water jet 8.1. Trigger is not
squeezed
8.1. Squeeze the trigger
8.2 Trigger lock is
activated
8.2 Deactivate the trigger
lock
8.3 No water supply 8.3 Check water supply
8.4 Filter is dirty 8.4 Clean filter
8.5 Hose blocked 8.5 Check hose
8.6 Nozzle blocked 8.6 Check nozzle
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 36 5/28/20 8:31 AM