MAC3 PresSystem - LED Indicators for Restart, Dry Running, Current

manual utilizare presostat electronic
pressystem
23
PresSystem vers. fara Cosφ:
PresSystem without Cosφ:
2. Dupa ce va asigurati ca toti robinetii sunt
inchisi, apasati butonul ON/OFF pentru a
porni PresSystem. Dispozitivul proneste
pompa pentru aprox. 40 secunde. In
acest timp se atinge maximul presiunii ce
va fi folosit pentru controlul instalatiei. La
sfarsitul celor 40 sec. PresSystem
opreste pompa si astfel se obtine:
 Presiunea minima (de repornire): LED
PR.RESTART
 Pragul presiunii minime pentru protectia
Lipsa Apa: LED DRY RUNNING
2. After making sure that you have closed all
taps, press the ON/OFF button to turn on the
PresSystem. The PresSystem drives the
pump for about 40 seconds. In this time is
acquired the maximum pressure which will
be used for the system management.
At the end of this time the PresSystem turns
off the pump and by the maximum pressure
acquired is obtained:
 the restart pressure: LED PR.RESTART
 the pressure threshold for the dry
running protection: LED DRY RUNNING
PresSystem vers. cu Cosφ::
PresSystem Cosφ version:
3. LEDul CURRENT lumineaza intermitent si
se afiseaza valoarea implicita a amperajului.
4. Setati valoarea dorita a amperajului conform
caracteristicilor tehnice ale pompei:
Apasati butonul + pentru a creste valoarea si
butonul – pentru a o scadea.
5. Apasati butonul EDIT pentru a salva datele
introduse, sau apasati butonul ON/OFF
pentru a iesi fara salvare. Dupa setarea
amperasjului LEDul PRESSURE lumineaza
si pe display va fi afisat:
3. The LED CURRENT flashes and displays the
current value of default.
4. Set the value of the rated current of the
pump: Press the + button to increase the
value and - to decrease it (it is advisable to
check the actual maximum current of the
pump).
5. Press the EDIT button to save the entered
data, or press the ON/OFF button to exit
without saving the data.
After setting the current, the LED
PRESSURE lights up and the device
displays:
3. Dupa ce va asigurati ca toti robinetii sunt
inchisi, apasati butonul ON/OFF pentru a
porni PresSystem. Dispozitivul proneste
pompa pentru aprox. 40 secunde. In
acest timp se atinge maximul presiunii ce
va fi folosit pentru controlul instalatiei. La
sfarsitul celor 40 sec. PresSystem
opreste pompa si astfel se obtine:
 Presiunea minima (de repornire): LED
PR.RESTART
 Pragul presiunii minime pentru protectia
6. After making sure that you have closed all
taps, press the ON/OFF button to turn on the
PresSystem.
The PresSystem drives the pump for about
40 seconds. In this time is acquired the
maximum pressure which will be used for the
system management.
At the end of this time the PresSystem turns
off the pump and by the maximum pressure
acquired is obtained:
 the restart pressure: LED PR.RESTART