madjax speaker box w/ built-in
bluetooth miniamp, 5” speakers, and power center
installation instructions
included: tools needed:
Madjax recommends professional installation. If you choose to not have this product installed
by a professional, we highly recommend that you exercise caution, care, and patience when
installing this product as it involves drilling holes into your cart’s body.
To begin remove your front seat leanback and
bottom cushion.
Attach supplied fastening tape to the speaker
box as shown. Now peel lm off bottom side
fastening tape. This will secure box to car. Use
a tape measure to nd center point of car and
attach box.
NOTE: This box is specically designed to t
between the golf car front seat and your Madjax
rear seat kit.
CAUTION: This mini amp is
designed to work on 12 Volts
only. A MJ1612VR or MJ1230C
is highly recommended to avoid
failure of mini amp.
Speaker Box
•Mini Amp with Built-in Blue tooth
•Power Center
•5” Speakers w/ Wire
•Fastening tape 3 - 75mm pieces
1/2” Drill Bit (optional)
Cordless Drill (optional)
Tape Measure
13-002
To Next Page
General