To Next PageTo Next Page
Need help?Do you have a question about the MAER IDROPULITRICI AVANT X 200/21 and is the answer not in the manual?
Mandates the use of PPE according to local laws and employer guidelines.
Outlines requirements for personnel involved in installation, use, or maintenance.
States that manual instructions supplement, but do not replace, general safety norms.
Obliges technicians to report any defects compromising safety.
Prohibits use in environments with inflammable materials or suspended particles.
Prohibits smoking and open flames during fuel tank filling.
Warns about the harmful effects of inhaling exhaust gases like CO.
Emphasizes avoiding unsafe cables and touching wet electrical parts.
Prohibits directing the water jet at people, animals, or electrical components.
Instructs to disconnect and contact assistance if defects are found.
Warns against leaving the running cleaner unsupervised, especially with children.
Details connection to single-phase (230V) or three-phase (400V) power.
Details requirements for the power cable, plug, and extensions.
Specifies a minimum water supply pressure of 2 bar to prevent pump damage.
Guides setting the interrupter and thermostat for startup.
Guides turning the switch IF to 'O' after cooling the coil with cold water.
Alerts that operating the pump without water can damage seals.
Forbids maintenance while the machine is operating or under tension.
General| Voltage | 400V |
|---|---|
| Input Voltage | 400V |
| Protection | IP55 |
| Cooling | Air |
| Frequency | 50 Hz |
