8
- After using, disconnect the appliance from the mains, disconnect
the bottle from the electric driver body by turning it counter-
clockwise. Install it on an even, stable surface upwards with the
drive of the shredder. Replace the drive of the shredder by the lid.
Preparation for work
- Before the rst use remove packing material, make sure that all
parts of the device are not damaged.
Before the rst use wash all removable parts with warm water and
detergent and thoroughly dry.
- It is prohibited to submerge the case of electric drive, its mains
connector and the plug in water or any other liquid.
Attention! At the time of the rst switching on the device, a specic
smell or smoke may appear for a short time. These are normal
phenomena due to the presence of preservation materials on the
electric drive motor. They shall disappear after several minutes of
the device operation.
To Next Page
Loading...