Assembly Instructions
Step 4:
1. Stake the tent by inserting the stakes
through the pin-rings on base of the tent.
Make sure the base of the tent fully spread
out.
2. Stake out guy lines away from the tent
with lines at roughly a 45°angle to the
ground. (E)
3.Put the lamp into the mesh pocket on the
roof (F) and press the power button on
remote control.(G).
Step 3:
1.Insert 4pc steel leg poles into the
hub with no color(B), then insert the
pin at bottom of inner tent into the
bottom end of leg poles(C).
2. Attach G-hooks on the fabric roof
to the frame. (D)
Page 5 of 8
To Next Page
Loading...
