Step 3:
1. Slide the ridge pole (B2) cross
the top of front pole (B1) and go
through the opening below of the
front pole sleeve located underneath
the rainfly. Place the end into
webbing pocket of the front eave.
Put the other end of the ridge pole
into eyelets of the back webbing.
2. Attach all the black G hooks to
the poles. (3)
Assembly Instructions
5
Step 4:
1. Pull the rainfly and make sure it is
at correct position. Attach the S-
hook to the ring at the back of the
tent. (4)
2. Stake the tent by inserting the
stakes (G) through the webbing
loops on base of the tent. Make sure
the base of the tent fully spread
out.(5)
3. Stake out guy lines (F) away from
the tent with lines at roughly a
45° angle to the ground. Adjust
using the plastic sliders. (6)
To Next Page
Loading...
