4
The inability to capture all of the vapor that is formed in one
breath is a sure sign that you've overloaded your screen with
too much concentrate material.
The screen is not meant to be scraped... if your material is sticky, engage the
power before use to warm the screen prior to loading your
material.
Doing so will allow your concentrate to slide on & absorb
optimally into the screen before vaporization.
load & draw
USE A TINY DAB... SINGLE HIT only! Overloading the screen leads to a waste of
your concentrate material & only makes a mess!
Begin to draw IMMEDIATELY... just before engaging the battery or rheostat &
continue to until there is no more visible vapor.
To Next Page
Loading...