Magic-Pak HWC8-24 - Burner & Manifold Assembly Removal

Page 12 of 18 507388-01Issue 1504
Burner & manifold assembly
To remove the burner & manifold assembly:
1. Disconnect electrical service and turn o gas to the appliance.
2. Loosen the pipe union external to the unit and remove the
gas line to the gas valve.
3. Disconnect the orange high voltage spark wire at the ignion
control board.
4. Disconnect the white ame sensor wire at the ame sensor
on top of the burner assembly.
5. Disconnect the orange wires at the rollout switch.
6. Disconnect the red and blue wires at the gas valve.
7. Refer to Figure 6. Remove the two screws on the burner
assembly that secure it to the mounting brackets. The
mounng brackets contain pins to locate the assembly and
hold it in place aer the screws are removed. The mounng
brackets are hidden unl the burner assembly is removed.
8. First, carefully pull the burner assembly toward you unl it
is clear of the locang pins in the mounng brackets.
9. Then move the assembly away from the vest panel.
10. Finally, pull the assembly from the unit.
11. Once the burner assembly is removed, the burners can be
cleaned using a bole brush.
12. For reassembly, follow the above steps in reverse order.
Control board mounng bracket