Magic MISTER KOOL II - User Manual

Office: (804) 230-1500
Magic Special Events
www.MagicSpecialEvents.com
Fog Machine

Summary

Introduction and Safety

Safety Precautions

Provides essential safety guidelines for operating the fog machine to prevent hazards like electrical shock and fire.

Fog Machine Setup

Step-by-Step Assembly

Detailed instructions for assembling and preparing the Mister Kool II fog machine for operation.

Operating and Troubleshooting

Operating Modes

Explains how to use the remote for manual, continuous, or timer-based fog output with LED indicators.

Troubleshooting Common Issues

Guidance on diagnosing and resolving problems such as low fog output, pump noise, or no output.

Overview

1. Function Description
2. Important Technical Specifications
3. Usage Features
4. Maintenance Features

The Mister Kool II is a fog machine designed to produce a ground effect, enhancing dance floors, entryways, and Halloween effects. It comes with a timer remote control for versatile operation.

Function Description:

The Mister Kool II creates a fog effect by heating fog fluid and dispersing it. Its primary function is to generate a low-lying fog that stays close to the ground, adding a dramatic or atmospheric element to various settings. The unit requires ice to cool the fog, ensuring it remains at ground level.

Important Technical Specifications:

While specific power ratings and fluid consumption rates are not detailed in the provided pages, the manual emphasizes the importance of a matching power supply and proper ventilation. It also notes a 3-minute warm-up time before the unit is ready to emit fog. The device uses a proprietary fog juice, and running it dry can lead to pump failure or clogging.

Usage Features:

• Set-Up:

  • Place the machine on a flat, dry surface.
  • Unscrew the knob on top and open the unit to fill the inside with ice.
  • Remove the reservoir cap and fill the reservoir with the provided fog juice only.
  • Insert the water tube into the water bag, which collects melted ice.
  • Firmly attach the remote control to the socket on the rear of the unit.
  • Plug the unit into a matching power supply and turn the power switch to the "on" position.
  • Allow 3 minutes for warm-up before operation.

• Remote Operation: The included remote control offers several modes of operation:

  • "On/Off" Button (Yellow LED): Activates the timer function. The yellow LED above this button glows when the timer function is active.
  • Continuous Button (Red LED): Allows for continuous fog output as long as the button is pressed. The red LED above this button glows when the unit is powered up and the remote is plugged in.
  • Manual Button (Green LED): Provides manual control of fog emission. Fog will emit as long as this button is pressed. The green LED above this button glows when the machine is warmed up and ready.
  • Timer Function (Yellow Timer Button): Emits fog at designed intervals. Pressing the yellow timer button activates this function, and a yellow LED will glow.
    • "Duration" Knob: Controls the length of each fog burst. Turning clockwise increases duration; counter-clockwise decreases it.
    • "Interval" Knob: Controls the time between bursts. Turning clockwise increases the interval; counter-clockwise decreases it.

• Safety Precautions:

  • Prevent water or other liquids from spilling into or onto the fogger. Keep fog fluid within the reservoir.
  • Disconnect main power when the unit is not in use for extended periods.
  • Do not operate if the unit or power cord is damaged, frayed, or broken.
  • Do not remove or break off the ground prong from the electrical cord.
  • Ensure ventilation holes are not blocked. Mount the unit in an area allowing proper ventilation, with at least 6 inches (15 cm) between the device and a wall.
  • Route power cords away from foot traffic to prevent tripping or pinching.
  • Be aware that fog machines may set off smoke alarms.

Maintenance Features:

• Fluid Management: Always maintain an adequate supply of the provided fog juice in the fluid reservoir. Running the machine dry is the leading cause of pump failure and/or clogging.
• Troubleshooting: If experiencing low fog output, pump noise, or no fog output, immediately disconnect the unit and discontinue use. Do not continuously press the remote control's activation button, as this can damage the machine.
  • Check the fluid level.
  • Check the external fuse or breaker.
  • Verify the remote connection.
  • Ensure the wall outlet is providing power.
  • If all these checks are satisfactory and the unit still malfunctions, service may be required. Contact the office for assistance.

Magic MISTER KOOL II Specifications

General

Brand	Magic
Model	MISTER KOOL II
Category	Fog Machine
Language	English