UNPACKING INSTRUCTIONS
1. THE FOLLOWING TOOLS ARE REQUIRED: A PRY BAR, 3/8” DRIVE RATCHET OR
DRIVE ADAPTER AND CORDLESS DRILL, 9/16” OR 14MM SOCKET, 3/4” OR 19MM
SOCKET, 3/8” HEX WRENCH, AND 3 PEOPLE.
2. USING A FLAT HEAD SCREWDRIVER OR PRY BAR, REMOVE THE 4 CLAMPS
FROM THE FRONT OF THE CRATE, REMOVE THE CRATE DOOR, REMOVE
FOAM FROM CRATE DOOR AND SET DOOR ASIDE IN A SAFE LOCATION.
3
. USING A 3/8” DRIVE RATCHET OR
CORDLESS DRILL WITH A 9/16” OR 14MM
SOCKET BIT REMOVE THE 6 BOLTS
FROM AROUND THE BOTTOM OF THE
CRATE.
To Next Page
Loading...