Magico LLC, 932 Parker St. #2, Berkeley, CA 94710
Tel: 510-649-9700, Fax: 510-649-1180
www.magico.net
V3 Hex Bolt Tightening Procedure
To keep your Magico V3s performing at their best, the V3 hex bolts on
the front baffle should be tightened periodically, just like you would
tighten woofer screws. It is a very simple procedure to tighten the
bolts. All that is required is a 3/16” hex wrench. You will notice in the
image and on your V3s that from top to bottom there are 6 rows of
bolts. Except for the second pair from the top, all other bolts should be
tightened very securely using only the hex wrench. The second row of
bolts should be tightened firmly, or simply finger tight. Following this
procedure on a regular basis will insure that your V3s will always
deliver optimum performance. Bolts should be tightened to a
maximum of 11 newton-meters.
To Previous Page
Loading...