10
PREPARATION
Before you connect:
Be sure your antenna or other device s connected properl/
Delore plu,_gng In the AC _ower cote1
Antenna Connection
Connect the Rt coa×lal cable o _our home outlet to the
_[/_enna IRDU_ ack of this unit
VHF/UHF
analogor
DTV antenna
®
®
®
®
®
e
®
_.Fcoaxial cable
®
cable TV signal
Once connect ons are completed.turn on the unt and begin
nitial setup. Channel scann ng s necessary for the unit to
memorize all available channels n your area. [Initial Setup]
,,_ p.11
No_,
If you have any quest on about the ©TV's antenna, vsit
www.antennsweb.o% for further nformation.
Depending on your antenna system, you ms>, need d fierent types
of comb nets (mixers) ol- separators (sp tters) for HDTV signa
the rain mum RF bandpass or, these devces is 2,000b1Hz ol- 2GHz.
For your safe,t>, nd to avod damage to this unt, please unpu£ the
RF coaxa cable flsm the antenna input jack before movng the
unit.
If you did use an antenna to rc.ceve ana ogTV, t should aso
wofl< for DTV mcept or,. Outdoor or stt}c antennas w be more
eff_,ct ve than a sot top or inside antenna.
lb switch your mcept on source easily br,tween antenna and cabe,
nstall an antenna selectoE
If you a_r, not receiv ng a sgna flsm your cable serv ca, contact the
Cabe prov dens
Connection to Cable Receiver or
Satellite Box
Use an HDbql or ComponentV deo cables to connect the
HDMI or the ComponentV deo input jacks of the unit to the
HDPll or the ComponentV deo output jacks of the cable
race ver/satellite box.
if/ou connect to the unit's ComponentVideo input jacks,
connect Analog Audio cables to the Analog Audo L/R input
jacks right below the ComponentVideo connector jacks.
satellite dish
cable TV signal
including PPV
RF coaxial cabl_.
_ompone ....
(red/blu6/green) and
audio cables
®®®®
cable receiver/satellite box
$ For 32NF301B, you can also use the HDNI jack on the Rear Panel.
You can also connect this unit to the cable receiver or satellite
box other than the HDMI or the ComponentVideo output jacks
or CompositeV deo output jack (n,_ p.26) because they might
have different output jacks.
Requ red cables and connecting methods of the cable receiver/
satellite box, or the ava lability channel for the dear QAbq may
dffer depend ng on the cable/satellite prov der or IocaF[V
broadcasler:
For more nformation, please contact your cable/satellite provider
or local IV broadcasten
Noe
• Use an HDPII cabe with the HDPll logo (a ca/tiffed HDbll cable),
Hgh Speed HDISl cable s recommended for the better compat bi i%
Plug In theAC Power Cord
Nake sure that the AC power cord must be plugged to an AC
outlet after all the necessary connections are made.
C_ut o/:
Do not connect the AC power colx) to a powor suppy outs de
the nd catr'd vo}tage ofths unit (AC 120V).
Connect ng the AC power cord to a power suppy outs de of this
range may re,sut in fire or eectr ca shocks.
Noe
Each timr, you pug n the AC power colx:], no operations will be
performed for a f_,w seconds.This is not a malfunct on.
To Next Page
Loading...
Need help?
General