Need help?Do you have a question about the Magneti Marelli BAT508 and is the answer not in the manual?
Summarizes safety advice regarding explosive gases, handling the battery, and following manufacturer instructions.
Battery capacity is good; check gravity if not fully charged.
Compare load test results with meter cover for status.
Unsatisfactory capacity; check gravity and condition.
Battery may be defective (e.g., a bad cell).
Explains 'c.b' display for voltage conditions and required actions.
Details how to adjust battery rating by steps for temperature compensation.
Steps to test charging system performance after battery testing.
Identifies excessive starter current draw by monitoring voltage during cranking.
General| Category | Test Equipment |
|---|---|
| Manufacturer | Magneti Marelli |
| Model | BAT508 |
| Type | Battery Tester |
| CCA Range | 40 - 2000 CCA |
| Display | LCD |
| Testable Batteries | AGM, Gel, EFB |
| Standards | IEC, DIN, SAE, EN |
| Voltage Range | 6V and 12V |
To Next Page
