Magnitone FACEROCKET - Page 8

14 15
x3
x3
FIRM
RADIOFREQUENCY + RED LED LIGHT THERAPY
Firm + tighten the skin with Radiofrequency + Red LED, working together below
the surface to stimulate collagen + elastin production. Do not use FIRM Mode
more than once every 3 days.
1. Before you begin, make sure your skin is fully cleansed
- free of makeup, surface oils and daily grime (A).
(Men should shave before treatment as facial hair can
interfere with conductivity).
IMPORTANT: Any cream, lotion, self-tan, or other oil-based
products on the skin can block the radiofrequency.
We recommend a full double cleanse;
try our WipeOut Amazing Microfibre
Cleansing Cloths to get rid of makeup
and surface dirt, then supercharge
your second cleanse with one of our
award-winning cleansing brushes!
x3
x3
x3
x3
x3
x3
x3
x3
A
B
C
D
x3
x3
E
x3
x3
x3
x3
x3
x3
2. Press and hold the power button to turn on FaceRocket
®
.
It will automatically start in FIRM Mode (B).
3. While the device warms up, apply a generous layer of
Superconductive Gel to your skin (C). You can apply
to the whole face or section by section, and re-apply
throughout the treatment as necessary.
IMPORTANT: You must use a Superconductive Gel to help the
radiofrequency reach below the skin’s surface. Without it, the
treatment will not work.
4. Starting at the chin, place the head of FaceRocket
®
flush
to your skin and gently move in small circular motions
(D). After 5 seconds you will hear a beep, this means
you need to move on to the next section of your face.
Always keep FaceRocket
®
moving in FIRM Mode. Do
NOT hold in one place.
5. Work along the jawline up to the ear on one side of
your face (E), then repeat this section of your face 2
more times. So you’re doing 3 x 'repetitions' in total.
F
G
H
x3
x3
I
6. Using this same technique move on to the next section of
your face and continue to work around your face (F):
• Corner of mouth to ear.
• Under eye/cheekbone to ear (Do NOT use on the eye
lid / delicate eye area).
• Forehead.
• Under chin.
Apply more gel as necessary.
7. Once you have completed your whole face, you can
go back and work on any specific problem areas such
as smile line, frown lines or crows feet (G). To do this,
gently move FaceRocket
®
in small circular motions for
15 seconds (3 x 5 second beeps).
8. When you're done, remove any excess gel with a clean,
damp cloth (H) and complete your skincare routine as
normal.
9. Wipe clean the head of your FaceRocket
®
using a damp
cloth (I). Do NOT rinse with water.
EN EN