© Copyright Mahindra and Mahindra Ltd. 092018
4-13
4.5 Replacing Smart Key Battery
If the operation range of your smart key is dramatically decreased
or the smart key does not operate intermittently, replace the
battery of the smart key. The internal circuit of the smart key may
be broken by the static electricity. Therefore, if you have any doubt
about your ability to replace the battery, visit Mahindra Authorised
Service Centre for servicing.
Type A Type B
• Use only the specified battery. The smart key may not work
properly because of improper contact when using a battery
with non-original dimensions
• Do not mistake the polarity
• Used batteries should be disposed of in compliance with
local regulations
• The smart key is not waterproof. A damaged key due to
water exposure (e. g. beverages, moisture, etc.) will not be
covered by your warranty
Y4D021
Specification One battery (CR2032)
Battery Voltage
3 V
Battery Capacity
225 mAh
• Remove the cover at the back side of the smart key using a
smallest flat-bladed screwdriver, taking care not to scratch the
cover
• Remove the rear cover and replace the battery
• Instal a battery (one battery - CR2032) that meets the
specifications with the correct polarity
• Assemble in the reverse of removal
STARTING THE ENGINE AND DRIVING THE VEHICLE
To Next Page
Loading...
