4-16
© Copyright Mahindra and Mahindra Ltd. 092018
If the selector lever is locked in the “P” position, release it by
following the above instructions and have your vehicle serviced
by the nearest Mahindra Dealer or Mahindra Authorised
Service Centre.
4.7.3 R: Reverse Position
Use this position to reverse the vehicle. To shift into “R” from “P” or
“N”, completely stop the vehicle and depress the brake pedal. When
the selector lever is in “R”, the parking aid system will be activated
(If equipped).
• Never shift into “R” when the vehicle is moving
• Please note that the vehicle may slowly move rearward when
the selector lever is at “R”
4.7.4 N: Neutral Position
No power is transferred in this position. At this position, the engine
does not transfer power to the wheels and the vehicle will not move
on a flat road. However, for safety, apply the brake when the gear is
in this position. To shift into “D” or “R” position from “N” position
after stopping the vehicle, you have to depress the brake pedal with
the ignition switch “ON”
• Warm up the engine for approx. 3 minutes when the
ambient temperature is below -15° C. Otherwise, the gear
selector lever may not be moved smoothly (N→R). It is
designed for protecting the vehicle and is not a fault
• Never shift into “N” from the “D” position or vice versa when
the vehicle is moving, or the transmission will be damaged
• If you have to stop on a hill and would like to use this neutral
position, depress the brake pedal firmly
STARTING THE ENGINE AND DRIVING THE VEHICLE
To Next Page
Loading...
