© Copyright Mahindra and Mahindra Ltd. 092018
4-49
5.
The colour of AUTO HOLD indicator on the instrument cluster
is changed from green to white and the brake is released.
• The AUTO HOLD function will not be activated when the
driver door, engine hood or tailgate is not closed or the seat
belt is not fastened
• When driving off on a downhill by depressing the accelerator
pedal, be careful as the vehicle can accelerate suddenly
Auto hold indicator
ON in white: AUTO HOLD operation READY state
(parking brake not applied).
ON in green: AUTO HOLD activated and parking brake applied.
Flashing in yellow: fault in AUTO parking brake system.
• The AUTO HOLD can be activated while reversing. To park/
stop the vehicle, deactivate the AUTO HOLD function
• During the break-in period of parking brake pad, the braking
force of the parking brake may be reduced. (slight rolling
may occur on a hill)
• Check the brake pad for wear and check the EPB operation
every 10,000 km
• A mechanical noise can be heard during the EPB operation.
This is normal
• Do not depress the accelerator pedal abruptly with the
AUTO HOLD function is activated. Otherwise, the parking
brake is released and the vehicle can accelerate suddenly
• If the EPB warning lamp is turned on or there is a fault in the
EPB system, have the vehicle checked and serviced at a
Mahindra Dealer or Mahindra Authorised Service Centre. If
parking the vehicle is required in an emergency, pull over the
vehicle on a flat surface and chock the wheels after shifting
the gear selector lever to the P position
• If the ignition is turned off during the AUTO HOLD ready
state (indicator ON in white)/AUTO HOLD operation
(indicator ON in green), the EPB will be released
automatically
• If wheel drive is required when e. g. going through an
automatic car wash, make sure that the AUTO HOLD is
deactivated
STARTING THE ENGINE AND DRIVING THE VEHICLE
To Next Page
Loading...
