6-18
© Copyright Mahindra and Mahindra Ltd. 092018
6.5.1 Trip Computer Menu
Distance to empty/Average fuel economy/Instantaneous fuel economy
Distance to empty
The Distance To Empty (DTE) displayed on the LCD screen is a
calculated value based on the measured fuel volume in the fuel tank,
average fuel economy, and information about the driving pattern.
The display range is from 0 to 1500 km. If the remaining distance
is less than 50 km, “—“ symbol will blink on the display.
For supervision type, the colour of the DTE value displayed on
the screen will change to yellow if the value becomes 100 km
or less, and the “——” symbol will be displayed in red.
The actual amount of fuel remaining in the fuel tank may differ
from the amount estimated by the trip computer depending on
the driving conditions of the vehicle and whether the vehicle is
level or not. That is, the DTE is only for reference. It is
recommended to refuel before the fuel warning light comes on.
Average fuel economy
This mode indicates the average fuel economy computed based on
the total amount of fuel used and the distance driven since the
reset to (–.–). This value shows how far the vehicle could go (in km)
with one litre. This value will be updated every 10 seconds on the
display. The average fuel economy is calculated continuously as long
as the engine is running regardless of the vehicle movement.
Instantaneous fuel economy
The instantaneous fuel economy is calculated based on the
distance driven and the amount of fuel used. This value is displayed
when the vehicle is driven at 10 km/h or more and the value is
between 0 and 30 km/L.
Reset: Average fuel economy
Press and hold the (8 ) switch in current mode. The value will be
reset and “–.–” will be displayed. Drive for a few miles so that the
average fuel economy values since the last reset are shown again.
You can reset this value at the time of IGN OFF, IGN ON, or
refuelling depending on the vehicle settings.
CONVENIENCE SYSTEM II
To Next Page
Loading...
