Lift the wiper arm from its position. Expose the blade lip for inspection. Clean the wiper blade lips with water applied
with a soft sponge. If the wiper blade is not wiping the glass satisfactorily or is worn-out, cut, cracked or bulging get it
replaced at an Authorized Mahindra Dealer.
13.6.11 Changing the Wiper Blade
1.
Lift the arm and position the wiper blade at right angles to the wiper arm
2.
Press the retaining clip in the opposite direction, disengage the wiper blade and pull it off the arm
To prevent damage to the windshield, don’t let the wiper arm slap down on to it.
3.
Hold the end of the rubber and pull until the tabs are free of the metal support
4.
Carefully insert the new blade rubber. Then install the blade assembly in the reverse order of removal
13.6.12 Clutch Fluid Checking
The clutch fluid level should be between the “MIN” and “MAX” lines during normal operating range; there is no need
to add fluid. If the fluid level is below the “MIN” mark, the performance of the clutch could be compromised; the clutch
operation could be spongy and gear change harder. Top-up the recommended clutch fluid immediately.
13.6.13 Draining Water from Fuel Filter
To prevent fuel system trouble, the water accumulated inside the fuel filter needs to be drained off.