To properly aim the head lamp beam, use the head lamp leveling switch. This switch is located on the right side of
the steering column shroud in the instrument panel. This switch has three positions marked as 0, 1,2 & 3.
Switch Position Vehicle Loading Condition
0 Driver only or Driver with Front Passenger
1 Driver + Front passenger + Rear seat occupied
2 All Seats occupied
3 All seats occupied with luggage OR Driver with luggage at extreme rear side.
Select the suitable switch position depending on the pay load as advised in the table.
The head lamp leveling should be done when the head lamp low beam is ON.
7.4.10 Hazard Warning Lamp
The hazard warning lamp switch is located on the instrument panel below the DDAS bezel between the central AC
louvers.
To turn the hazard warning lamp ON, push the switch in. All the turn signal lamps flash. The instrument cluster turn
indicator lamps also flash indicating the same. To turn OFF, push the switch again.
Use the hazard warning lamp when your vehicle is stationary or to warn other road users to be cautious while
passing your vehicle.
The turn lamps do not work when the hazard warning lamps are operational.
In bonnet open condition; the hazard warning flashes regardless of turn indicator position provided parking lamps are
ON, vehicle is stopped and bonnet is open. This activates irrespective of IGN switch position. Pressing the hazard
switch twice de-activates this feature. Mahindra authorized dealer can deactivate this feature permanently if not
required.
7.5 Interior Lamps
https://owner-manual.withyouhamesha.com/manuals/BoleroPower%2B/index.html
To Next Page
Loading...
