2.
Lift the hood a little to access the safety latch holding the hood striker. This safety latch is located below the hood
at the center
3.
Move the safety latch to the left and lift the hood to as much height as required
4.
While lifting the hood, release the unhinged end of the stay rod from its lock clip, swing the rod upwards and insert
its unhinged end in the slot below the already lifted hood
5.
Allow the hood to be supported by the stay rod
6.
Do not apply any undue force on the bonnet when it is supported by the stay rod
•
Do not open the hood immediately after a drive; the engine compartment will be very hot.
•
Always double check to be sure that the hood is firmly latched before driving away. If it is not latched properly,
the hood could open while the vehicle is being driven, causing a total loss of visibility, resulting in an accident.
•
Do not move the vehicle with the hood in the raised position, as vision is obstructed.
13.3 Closing the Hood
1.
Remove the stay rod supporting the hood by slightly lifting the hood
2.
Slowly lower the hood, while swinging down the stay rod and locking its unhinged end in the lock clip
3.
Bring the hood just a few inches above its fully closed position
4.
Now, release the hood and allow it to fall by its own weight. This ensures that safety latch firmly locks the hood in
its fully closed position
13.4 Identifying Components in the Engine Compartment
To Next Page
Loading...
