It is important to drive your vehicle properly during initial 1000 km to ensure longitivity
and hassle free running. New engine components initially wear in quickly.
Please follow underneath instructions during "Running-In" period :
Do not exceed
ation.
After you start the engine, run it at idle for a minute to enable the oil to lubricate
entire the engine.
Cleaning Procedure :
Avoid spraying water under high pressure at the following areas :
Wheel hubs, Silencer outlet.
Ignition switch, handlebar switches and other electrical parts.
Underseat storage.
Dry the motorcycle, start the engine and let it run for several minutes.
Test the brakes before riding in traffic. Applications of brakes several times may
be necessary to restore normal braking performance.
l
l
l
t
t
t
After cleaning, rinse the motorcycle thoroughly with plenty of clean water to avoid
l
corrosion by residual detergent.
l
l
a speed limit of 50 km/h
l Avoid full throttle operation, and rapid acceler
RECOMMENDED USAGE GUIDELINES :
Running in Procedure :
CAUTION :
Immediately after washing the motorcycle Braking performance may be impaired.
9
To Next Page
Loading...