Head Light Switch (2)
When the switch knob is turned to “ ” position while engine is running, head light,
tail light, licence plate light and meter light will be 'ON'.
When the switch knob is turned to “ ” position while engine is running, meter light,
position light, licence light and tail light will be "ON". Head light will be “OFF”.
When the knob is turned to “ l ” position - Head light, Tail light & Speedometer light
remain 'OFF'.
kdk
kdkd
RIGHT HANDLE BAR CONTROL
Right handle bar control switch consists
of Starter button (1) and Head light ‘ON
- OFF’ switch (2).
Starter Button (1)
Located below the headlight switch.
Before operating/pressing this button
make sure that the gear is in neutral
ignition key, switch
position by using
‘ON ‘ the ignition. Then press the starter
button. When pressed, the starter motor
cranks the engine.
20
CAUTION: Do not press the electric starter button for more than 3 seconds at a time.
Release the starter button for approximately 10 second before pressing it again. To
avoid damage to engine parts release this button immediately after engine has started,
and do not press the button again.
1
2
To Next Page
Loading...