Mahindra Cosmo User Manual

Diagnostic Manual ( EMS) LCV MDI BSIII CRDe
Rev 01- Mar 14
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of release.
The methods may be modified as a result of changes introduced by the manufacturer in the production of the various component units
and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of whole of the present
document, are prohibited without the prior written consent of 2014 Mahindra & Mahindra Ltd (Truck & Bus Division)
List of DTC codes
Group
Code
Label
Crank shaft sensor P0335 Crankshaft sensor no signal error
P0336
Crankshaft sensor signal error
P0371 F_M_Aps_crank_early_fault_rec
P0372
Shifted/Missing cam edge
Cam shaft sensor P0340 Camshaft sensor no signal error
P0341 Camshaft sensor signal error
Boost Pressure
Sensor
P0236
Calculated Boost pressure is not in the expected
range.
P0237
Signal range check for intercooler downstream
pressure sensor below minimum limit
P0238
Signal range check for intercooler down stream
pressure sensor above maximum limit.
P1235
Analogue to Digital convertor fault.
P1236
Boost pressure variation exceeds the max boost
pressure Gradient value.
P1237
Raw boost pressure falls below the calibrated min
value
P1238
Raw boost pressure exceeds the calibrated max
value
P0097
Boost temperature signal falls below a calibrated
value
P0098
Boost temperature signal falls above a calibrated
value
P007C
Signal range check for intercooler
downstream
temperature sensor below minimum limit
P007D
Signal Range Check for coolant temperature sensor
below minimum limit
Coolant
Temperature
Sensor
P0117
Signal Range Check for coolant temperature sensor
below minimum limit
P0118
Signal Range Check for coolant temperature sensor
above maximum limit

Mahindra Cosmo Specifications

General

Brand	Mahindra
Model	Cosmo
Category	Trucks
Language	English