Diagnostic Manual ( EMS) LCV MDI BSIII CRDe
Rev 01- Mar 14
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of release.
The methods may be modified as a result of changes introduced by the manufacturer in the production of the various component units
and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of whole of the present
document, are prohibited without the prior written consent of 2014 Mahindra & Mahindra Ltd (Truck & Bus Division)
Possible causes: Open circuit
Corrective action: Check for pin back out at metering unit or loose connector.
Check for pin bend or oxidation.
Wire cut.
P 0004: Metering unit short circuit to battery error.
This error is registered the short circuit to battery is detected
Effect: Lamp continuously ON. Engine will switch off
Possible causes: Check the wire from metering unit to EMS ECU.
Metering Unit
EMS ECU
Corrective action: Check for pin back out at metering unit or loose connector.
Check for pin bend or oxidation.
Wire cut.
P 0003: Metering unit short circuit to ground error.
This error is registered the short circuit to ground is detected
Effect: Lamp continuously ON. Engine will switch off
Possible causes: Check the wire from metering unit to EMS ECU.
Metering Unit
EMS ECU
Corrective action: Check for pin back out at metering unit or loose connector.
Check for pin bend or oxidation.
Wire cut.
P0001
P0002
P0004
To Next Page
Loading...