Diagnostic Manual ( EMS) LCV MDI BSIII CRDe
Rev 01- Mar 14
All copyrights reserved by
The repair methods given by the manufacturer in this document are based on the technical specifications current at the time of release.
The methods may be modified as a result of changes introduced by the manufacturer in the production of the various component units
and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of whole of the present
document, are prohibited without the prior written consent of 2014 Mahindra & Mahindra Ltd (Truck & Bus Division)
TO CHECK TO RECTIFY
1 Disconnect Injector and check connector 1. Rectify terminal back out/
Replace connector
2. Continuity between two injector
terminals
2. Replace injector if open circuit
3. ECU connection
3. Remove and refit connector.
4.Electrical continuity in wiring harness 4. Perform necessary repair
5.If problem persists 5. Replace injector
6. ECU 6. Replace ECU
For P268C ,P268E,P268F & P268D : Read
I2C/I3C from ECU
Enter correct I2C / I3C values
P1286
P1287
P1290
P1291
P1292
P1293
P1288
P1289
P268C
P268E
P268F
P268D
To Next Page
Loading...