Maintenance Manual MAN-00135
GENIO DC (BS-III & BS-IV)
JULY 2011/Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2011 Mahindra & Mahindra Ltd.
Recommended belt tension is 114±5 Hz. To be check between Alternator &
Dummy pulley.
Recommended belt tension for Power Steering Pump drive Belt is – New: 255
to 260 Hz & Used/ Stabilized belt: 215 to 225Hz.
Accessory Drive Belt tension to be check at 60000, 80000kms.
Accessory Drive Belt replacement interval is at every 100000kms.
Refer illustrations shown.
6. Chunk Out – Pieces or chunks of rubber material have broken off from the belt. When
chunk-out has occurred, a belt can fall at any moment.
7. Gravel Penetration – Small pinholes are visible on the backside of the belt. Bumps may be
visible and the fabric around the holes can be frayed.
8. Pilling – Belt material is sheared off from the ribs and builds up in the belt grooves.
To Next Page
Loading...
