Assembly: -
4. Fit Main bearing caps serially. i.e. 1 to 4 sequentially from front to rear. Tighten the opposite ½”-
13 UNC bolts simultaneously and apply 122 to 128 Nm torque.
5. Similarly tighten remaining bolts from inside out.
6. Cam shaft End Float measurement.
7. Fix dial gauge base on plane surface. Put dial gauge needle on can shaft under tension. Ensure
zero. Move cam shaft gear axially
8. Measure the reading. End float should be between 0.1mm to 0.4 mm If readings are not ok, then
replace thrust plate.
To Next Page
Loading...
