Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
the pedal lever, release pedal.
Screw out the bolt further by one turn. Tighten the
locknut.
Recheck pedal height.
Bleeding the clutch –
Clean the external areas of the clutch slave cylinder
and remove the dust cap of the bleeder screw.
If the bleeding operation is done by without
connecting by a tube and in the open air then the
chance of air remaining trapped is high.
Connect bleeding tube, to bleeding screw on slave
Ensure that the other end of the tube is fully
immersed in the bottle having clean clutch /brake
fluid.
Fill the Reservoir clutch master cylinder up to the
top level with recommended clutch fluid.
To Next Page
Loading...
