Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
• Rear Oil Seal Replacement (2WD) –
Follow below step If the Transmission assembly is not removed from the vehicle -
• Remove the Rear propeller shaft from the transmission end*
( Only front end of rear propeller shaft to be removed in case of 2WD vehicle)
•
The rear oil seal is fitted at the rear end of the
Transmission assembly.
The seal is protected by dust cover.
Refer illustration shown.
• Remove the dust cover from Transmission
assembly rear end.
Use mallet in case it found jam.
• Remove rear oil seal, using tool.
• Always replace with a new seal once it has been removed.
Installation –
• Before installation apply multi-purpose grease to lip of oil seal.
• Install new seal, press until it stops.
• Refit propeller shaft assembly.
Ensure that Seal is not getting damaged during assembling of propeller shaft to Transmission
assembly.
To Next Page
Loading...
