Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
• Gear Position/ Gear Neutral Switch Check -
If the vehicle is equipped with Engine “Stop-Start” feature, follow the procedure given below –
Micro hybrid vehicles are equipped with ‘STOP START’ system. The Gear neutral Switch is located on
the Adaptor Pivot Plate. Refer illustration below.
• Check continuity, refer below chart.
Switch Gear Position Continuity
Reverse lamp switch
Reverse Yes
Except Reverse No
Neutral Position Switch
Neutral Yes
Except Neutral No
Neutral switch should be fitted with 6 mm gap with sensor; Sensor is fitted on bottom gear
lever.
To Next Page
Loading...
