Repair Manual MAN-
00190
THAR CRDe BS-IV MAY 2012/Rev
1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by
the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
•
help of dowel. - Pivot pin facing downwards.
• Fit pivot pin with pivot insertion & pressing
impactor dolly.
• Apply silicon sealant on pivot.
• Fit pivot by tapping it.
• Use new Rubber grommet along with new
metal clip.
• Keep the clips of the metal tie clip towards
5
th
/rev gear side.
• Apply sealant (Anabond 413/ Loctite 648) on
breather cap.
Adapter Pivot & Gear Neutral Switch Fitment -
• Place the sensor on retainer plate.
• Put two lugs of sensor on plate hole and
press it.
• Fit two bolts of M8 40 on sensor lugs and fit
one bolt of M8 20 on plate. Torque them 29
To Next Page
Loading...
