Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra
& Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
Shifting Procedure
Shifting Between 2H and 4H
To shift from 4H to 2H, turn the selector switch
knob to 2H position. This can be done at any
speed from 0‐60 mph. 4WD HIGH lamp in the
instrument cluster goes out. If the lamp continues
to illuminate, drive straight ahead accelerating or
decelerating, or drive forward and backward in a
short distance. If the lamp continues to
illuminate, contact an authorized Mahindra USA
dealer as soon as possible. There may be a
malfunction in your four wheel drive system.
Your vehicle is equipped to shift from 2H to 4H
mode at any vehicle speed from 0‐60 mph. To
shift from 2H to 4H turn the selector switch to 4H
position. Once the shifting is complete 4WD HIGH
lamp in the instrument cluster illuminates. If the
lamp doesn't come on, drive straight ahead
ecelerating. If the lamp still
doesn't come ON, contact your an authorized
Mahindra USA dealer as soon as possible. There
may be a malfunction in the four wheel drive
system.
Never operate the selector switch knob if the wheels are slipping. Stop the slipping or spinning before
operating.
The vehicle uses automatic hub lock system to engage or disengage the front wheels. Once the 2H
mode is selected from either 4H or 4L, whenever possible drive vehicle in reverse direction for 1 to 1.5
meters to disengage the au‐tomatic locking Hubs. If the vehicle still seems to be engaging the front
wheels, drive the vehicle in reverse for further few meters to make sure that the auto hub locks are
disengaged completely.
To Next Page
Loading...
