Mahindra Thar CRDe - Special Tools

To Next Page

To Previous Page

Repair Manual MAN-00190

THAR CRDe BS-IV MAY 2012/Rev 1

The repair methods given by the manufacturer in this document are based on the technical specifications at the time of release. The methods may be modified as a result of changes introduced by the

manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the present

document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of

Lubricants & Sealants

Mahindra Maximile Supreme Or any other engine oil conforming to API grade CH4 or above and a

viscosity Index of 15W 40.

If any oil conforming to CG4 grade is used then the oil change interval is 7000 Kms. Oils of MIL 2104

C or below are not acceptable

RTV silicone sealant - RHODOSEAL. Part number 0024532 to be used:

 Between Rear oil seal retainer & Block

 Between ladder frame & block

All other places Loctite 547. Part number 0084337 are used.

Hard gaskets are used only at: -

 Cylinder head Gasket.

 Turbocharger to Exhaust manifold mounting.