Mahindra Thar CRDe - Air Filter Service Indicator - Removal; Clean Side Intake Hose - Removal

Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
Turbocharger Assembly Removal -
Remove the air cleaner assembly.
Remove the exhaust pipe from after the elbow.
(Access is only after lifting it on a two post or in a pit.)
Remove the air intake hose to turbocharger.
Remove the oil feed pipe and the oil return pipe.
It is suggested that all the opening in the Turbine housing, compressor housing and the center
housing be covered with plugs or masking tape.
This is recommended as even a small particle/ washer if trapped between the blades & housing can
destroy the turbocharger.
(It is recommended to apply rust cleaning spray in the nuts before attempting to remove otherwise
the stud will come off.)
Page 62