Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
Air Filter Service Indicator - Removal
1. Using a 0.67” (17mm) (A) open end
the service indicator (B)
mounting on the intake hose and using a
0.43”(11mm) spanner (C) remove the service
indicator.
1. Check the service indicator for any physical damage.
Installation
1. To install, reverse the removal procedure.
Clean Side Intake Hose - Removal
1. Using a 0.31”(8mm) socket and wrench
set,
loosen the clean side intake hose
lock clip screw (A) and detach the hose
from the filter assembly (B).
2. Using a suitable plier, pull back the clamp
and remove the posi
Disconnect the atmospheric pressure
hose (A) to the vacuum modulator from
the clean side air intake hose.
Inspection
1. Check the service indicator for any physical damage.
Installation
1. To install, reverse the removal procedure.
To Next Page
Loading...
