© Copyright Mahindra and Mahindra Ltd. 012019
8-37
88..1133..44 IInntteerrmmiitttteenntt ((IINNTT))
Intermittent (INT) wiping is selected when the wipe control stalk is
pushed down to position C. In the INT mode, the wiper operates on
preset intervals.
The delay between each wipe can be varied by rotating the wiper
speed intensity rotary switch (F).
88..1133..55 AAuuttoo MMooddee ((iiff eeqquuiippppeedd))
Auto mode wiping is selected when the wipe control stalk is pushed
down to position C. In the AUTO mode, the wiper operates based on
rain intensity.
The delay between each wipe can be varied by rotating the wiper
speed intensity rotary switch (F).
When the ignition key is in the “ON” position, the wiper will
automatically operate once if the wiper switch is turned from
the “OFF” to the “AUTO” position.
88..1133..66 LLooww SSppeeeedd WWiippiinngg
Push the wipe control stalk down to the position (D) to operate the
wiper at a fixed low speed.
88..1133..77 HHiigghh SSppeeeedd WWiippiinngg
Push the wiper control stalk down to position (E) to operate the
wiper at a fixed high speed.
The wipe/wash function can be activated only when the ignition
is in “ON” position.
88..1133..88 WWiippee//WWaasshh
Pull/Lift the wiper control stalk towards the steering wheel from
any position to activate wipe/wash function. Washer fluid from
front washer reservoir is pumped and sprayed onto the windshield.
The wipers wipe the windshield 3 times after the washer spray is
stopped. Hold the stalk in position for continuous spray of washer
fluid.
FFEEAATTUURREESS AANNDD CCOONNTTRROOLL
To Next Page
Loading...
